Your new led neon sign includes many free
features that you can use to advertise any
product or present any information to your
The basics of the sign works like this...
A) You add a '01' as your message text
B) You add more, 02, 03, 04 (up to 99) and store these
into the electronic sign.
C) You tell the sign, to play 01 or 02 or 03
or 04 or all.
The sign will then finish each program set
and repeat. The sign has an inbuilt memory
so if turned off / on. It will recognize the
last play list and continue.
You can have different colors and
E.g. The text can be Red
with scroll in from right, followed by Green
with explode in centre etc. There are many
The easiest way is to use the hand held
remote control unit. Turn on the sign then
PRESS > PROG > Enter > 01
This will show you the first preset
message we supply you.
start your sign. Please print this page
Please follow these
Program via Hand Held
Basic Sign Operation
in the sign to the power supply.
- Turn the sign ON or OFF – Press
Alt + Run
The sign has a memory hot key that
displays the message programmed.
To Program messages.
1. Press > PROG
2. Using Remote control ,Type > 01
3. Press > Enter
4. Use PREV or NEXT to change
5. Press > Right arrow key to find
start point (after animation point)
is the point to begin.
6. Continue to add your message
using CAP (Capitals), SPA (Space),
7. Press > RUN
8. Save Y/N
To make or change animations, at
the point where you would like an
1. Press ALT – ENTER at the Start
point of animation.
2. Use PREV or NEXT buttons to
change animation style.
3. At the end of desired animation
length. Press ALT ENTER choose other
opens immediately [SCROLL]This
scroll in from the side [FLASH]Flashing
Word [SCROLL] The
words scroll in again.
4. Press > Alt-SPE for [SPEED]
1. You can run a sequence of
messages e.g. 01, followed by 02,
followed by 06, 07 etc.
2. To begin a sequence, first you
must create two or more Messages
3. Press PROG
4. Type S1
5. Type 01 02 06 (as you require).
6. Press RUN
7. Save Y/N